Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EXTENSION CORDS
Use proper extension cords. Make
sure your extension cord is in good
condition and is a 3-wire extension cord which has
a 3-prong grounding type plug and matching
receptacle which will accept the machine's plug.
When using an extension cord, be sure to use one
heavy enough to carry the current of the machine.
An undersized cord will cause a drop in line
voltage, resulting in loss of power and overheating.
The table shows the correct gauge to use
depending on the cord length. If in doubt, use the
next heavier gauge. The smaller the gauge number,
the heavier the cord.
KEY FEATURES AND COMPONENTS
A. Infeed/outfeed table
B. Depth of cut adjustment
C. On/Off switch
D. Cutterhead (not visible)
E. Cutter guard
F. Fence angle lock
G. 45° bevel stop
H. Rear fence
NOTE: Located within the fence
mount is a red sliding guard.
Please insure guard moves freely
with fence.
®
The DELTA
37-071 is a 6" Bench Jointer with designed cutting capacity of 6" (152mm) width and 1/8" (3.2mm)
depth. It features a 110-volt, 10,000 RPM motor, an in-and-out, tilting center-mounted fence, and a two-knife
cutterhead.
FUNCTIONAL DESCRIPTION
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Volts
Rating
0-6
120
0-6
120
0-6
120
0-6
120
6-10
120
6-10
120
6-10
120
6-10
120
10-12
120
10-12
120
10-12
120
10-12
120
12-16
120
12-16
120
12-16
120
7
Total Length
Gauge of Extension
of Cord in
Cord
Feet
up to 25
18 AWG
25-50
16 AWG
50-100
16 AWG
100-150
14 AWG
up to 25
18 AWG
25-50
16 AWG
50-100
14 AWG
100-150
12 AWG
up to 25
16 AWG
25-50
16 AWG
50-100
14 AWG
100-150
12 AWG
up to 25
14 AWG
25-50
12 AWG
GREATER THAN 50 FEET NOT RECOMMENDED
Publicidad
Tabla de contenido
