TABLE 2 - TABLEAU 2 - TABELLE 2 - TABLA 2 - TAVOLA 2 (ITEM 07)
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO COOL
DOWN FOLLOWING UNINTERRUPTED
HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
BATTERY
OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
3.2) General information on how to use batteries
In order to use the batteries correctly, please follow these rules:
– Use the battery until the automatic residual energy display still has 1-2 LEDs showing: this
means the battery is almost completely discharged and no loss in the life of the battery has
been caused.
– Be particularly careful when charging a new battery the fi rst 2-3 times in order to be certain
of maximising the available energy level.
– Allow the battery to cool down to ambient temperature prior to recharging.
– Rest the battery charger for at least 15 minutes between charges.
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of
the tool:
4.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic
device.
Every day, after use, the tool must be wiped with
a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
4.2) Storage
When not in use, the tool should be stored and
transported in the plastic case, to prevent damage.
The case is suitable for storing the tool, the accessories
and up to 21 die sets and pre-prepared compression
connectors.
Plastic case: VAL P5, size 543x412x130 mm,
(21.4x16.2x5.1 inches) weighs 2,3 kg (5 lbs.).
30
7
,
SUCCESSIVE CRIMPING OPERATIONS
.
. W
. E
-
LECTRO
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING RAIN
.
(Ref. to Fig. 5)
ENGLISH
;
,
FOR INSTANCE
,
DELAY BATTERY
ATER WILL DAMAGE THE TOOL AND
FIG. 5