Technical Data; Range Of Usage; Tool Operation - Stanley MasterFix XGrip N09QI Manual Del Usuario

E N G L I S H

2.2. TEChNICAl DATA

weight ...............................................................................2,0 kg
working pressure ........................................... 0,5 - 0,7 MPa
stroke force at 0,6 Mpa ................................................ 23 kN
air consumption ............................................... 1,5 l / stroke
stroke .................................................................................8 mm
height ...........................................................................270 mm
lenght ...........................................................................262 mm
width (over the aircoupling) ............................... 125 mm

2.3. RANGE Of UsAGE

The pneumatic-hydraulic tool is designed for riveting with:
– rivet nuts M3 – M12 (aluminium, steel, stainless steel)
– rivet bolts M4 - M8 (aluminium, steel, stainless steel)

2.4. TOOl OPERATION

The manufacturer equipped the tool with a anvil and mandrel for rivet nuts M8. For riveting of rivets with a
different dimension it is necessary to exchange the anvil and mandrel and change basic set up and regulation
of the tool as following:
1) loosen the counternut of the anvil
2) screw out the anvil from the front nozzle
3) screw out the mandrel from the sleeve
4) choose appropriate anvil and mandrel, see the following chart:
Rivet nuts
M4
M5
M6
M8
M10
M12
5) screw the mandrel on to the sleeve (to the backstop) and then turn it back, so that the flats of the
hexagons of the screw-plug gauge and sleeve are matching.
6) slide on the anvil to the hexagons of the mandrel and sleeve.
7) screw on the anvil to the front nozzle.
8) set-up the anvil:
- for rivet nuts - the rivet nut is screwed on the whole length of the thread on the mandrel and the front of
the rivet nut leans on the anvil. Fasten the position of the anvil with a counternut.
- for rivet bolts - set-up the anvil so that there is about 1 mm space between the outer side of the rivet
bolt and inner side of the anvil. Do it as following: screw on the anvil to the backstop to the mandrel and
then screw it back one or two turns. Fasten the position of the anvil with a counternut.
9) connect the tool to the source of the compressed air
10) press and hold the trigger, find out the currently set stroke force from the force indicator, and release the
6
Anvils and mandrels
Mandrel for rivet nuts M4
Anvil for mandrel M4
Mandrel for rivet nuts M5
Anvil for mandrel M5
Mandrel for rivet nuts M6
Anvil for mandrel M6
Mandrel for rivet nuts M8
Anvil for mandrel M8
Mandrel for rivet nuts M10
Anvil for mandrel M10
Mandrel for rivet nuts M12
Anvil for mandrel M12
Spare part Nr.
D-1400104
S-1400324
D-1400105
S-1400325
D-1400106
S-1400326
D-1400108
S-1400328
D-1400110
S-1400330
D-1400112
S-1400332