Selecting A Location - STACK-ON QAS-1304-12 Manual De Instrucciones

PROGRAMMING YOUR OWN
COMBINATION
With the door open and the batteries installed you
can now program your own combination. For
security, you must reprogram your safe changing the
preset factory code (1-2-3-4). Write your new
combination on this form or store your combination
on our secure website at www.stack-on.com under
Service. If you write down your combination you
must keep this information in a secure place, away
from children, not inside the safe.
Press the button through the access hole on the back
of the door using a pen to press the button. The
yellow light will go on and you will have 10 seconds
to enter your personal ( 3 to 8 ) digit combination.
Press the button again to enter the new combination.
The yellow light will go out and your personal
combination has been entered.
Close the door and push the latch up to lock the
door. Enter your new combination and the green
light will go on. Push the latch down to unlock the
door.
SECURITY NOTE
If the combination is entered incorrectly the yellow
light will flash. If the combination is entered
incorrectly (3) consecutive times the keypad will
automatically lock out for 30 seconds. If the
incorrect combination is entered an additional (3)
times the keypad will lock out for (5) minutes
before you can try the combination again.
TURNING THE KEYPAD SOUND OFF/ON
You can turn off or on the "Beep" sound of the
keypad by pressing two buttons that are at opposite
corners from each other (1-4 or 2-3) at the same
time.

SELECTING A LOCATION

The safe is to be placed on a shelf and then secured
to the shelf. For optimal safety and security, the
safe should be installed in an isolated, dry and
secure area.
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
SECURING THE SAFE
NOTE: This safe is designed to be placed on a
shelf and then secured to the shelf. Failure to
place the safe on a shelf and then to secure to the
shelf will compromise the safety and security of
the safe.
NOTE ON LOCKING THE SAFE: The safe
needs to be in an upright position, as shown in
figure 2, for the locking mechanism to function
properly. Failure to mount the safe in the
corrrect upright position will compromise the
safety and security of the safe.
2
This safe has a mounting plate. After you have
mounted this plate, you will be able to install and
remove the safe from the plate to make the safe
portable. First remove the mounting plate by
loosening the thumb screw from inside the safe.
(Figure 3)
Mount the plate in the desired location using the
hardware provided. For mounting to a shelf, drill a
3/16" diameter pilot hole and attach the safe using
the 3/4" screws and washers.
Slide the safe on the mounting plate and tighten the
internal thumb screw.
2
15
40029-1306