STACK-ON QAS-1514 Manual De Instrucciones página 5

TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound
turned on. You can turn off the "Beep"
sound of the keypad by pressing all the
buttons at the same time and holding for 3
seconds until the green light flashes.
To turn the "Beep" sound on, press the left
and middle button at the same time and hold
for 3 seconds until the green light flashes.
Thumb nuts
Mounting
Bracket
REMOVING THE SAFE FROM THE
MOUNTING BRACKET
Open the holster compartment as described
in the Installing the Battery section. When
the holster compartment has been released
from the frame and the L brackets have
been rotated so they are flat against the
back of the holster compartment, locate 2
nuts which are located in the bottom of the
safe body. Remove the 2 nuts and washers
using your fingers and lift the safe off the
tabs in the back of the sleeve.
There are some securing tabs on the
mounting sleeve that guide the back of the
safe into position - you will need to make
sure you have maneuvered the safe out of
these tabs.
5
16
40543-1511