Publicidad
Idiomas disponibles
Idiomas disponibles
Wrapping Procedure
FIGURE A
______________________________________________________________________________________________________________
FIGURE C
______________________________________________________________________________________________________________
FIGURE E
Corvette "Stinger" Hood Decal
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Body Panel
Hood Decal
Edge of
Body Panel
Water
Alcohol
Use a covered squeegee to
apply pressure lengthwise
around the edge, working
toward the bottom.
Apply additional heat as
necessary
AUTH
REVISION
FIGURE B
FIGURE D
FIGURE F
PART NO.
IR 14JA14
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette "Stinger" Hood Decal
PART NO.
22989161
Use a lint-free towel to
wipe these areas until dry.
Apply heat across the
length of the decal
!
Be careful to not overheat
and melt the decal
5 seconds maximum per
!
2" area.
Use the squeegee to press
the decal onto the vertical
wall or underneath the panel
(lift the panel as necessary)
Apply additional heat as
necessary
22989161
SHEET
3
SHEET
3
12
OF
12
OF
Publicidad
