Delta 50-764 Manual De Instrucciones página 10

ALTERNATE SETUP
The steps so far will assemble the unit with the motor
on top and dust intake ports on bottom, as shown in
Fig 4.
This unit can be assembled with the intake port (A) Fig.
5 in the up position by following the steps in "LEGS TO
MOTOR/BLOWER ASSEMBLY." The exception is to
place the motor/blower assembly on a flat surface with
the motor (A) Fig. 6 facing up before attaching legs.
NOTE: BEFORE DOING THE ALTERNATE SETUP,
REMOVE 5/16" HEX HEAD SCREWS FROM HOLES (B)
FIG. 6 IN MOTOR/BLOWER ASSEMBLY AND PLACE
IN HOLES (C). AIR LEAKAGE WOULD OCCUR IF
SCREWS ARE NOT PLACED IN HOLES (C).
ATTACHING DUST INTAKE PORTS
DISCONNECT MACHINE FROM POWER
SOURCE
Place dust intake port (A) Fig. 7 over intake hole (B) op-
posite the motor. Align four holes (C) in the port with the
ones in the motor/blower assembly and fasten with four
M4 sheet metal screws.
Turn unit over so casters are on the ground.
BECAUSE OF THE WEIGHT OF THE
UNIT, MORE THAN ONE PERSON
SHOULD LIFT MOTOR/BLOWER ASSEMBLY INTO
UPRIGHT POSITION.
A
A
B
C
C
10
Fig. 4
Fig. 5
Fig. 6
A
B
Fig. 7