Adjust Telescopic Arm; Operating The Long-Handle Hedge Trimmers - Grizzly Tools AKHS 20 Set Traducción Del Manual De Instrucciones Origina

3. To turn off, release the On/Off
switch (9).
Starting without the
telescopic tube
1. Press the safety switch (21) on
the front handgrip (15).
2. To turn on, use your thumb to
actuate the switch lock (10), then
press the On/Off switch (9). Re-
lease the switch lock. There is
no continuous operation mode.
3. To turn off, release the On/Off
switch (9).
After turning off the appliance,
the trimming assembly will keep
revolving for some time. Allow
the trimming assembly to come
to a standstill. Neither touch nor
slow down the moving cutting
insert. Risk of injury!

Adjust telescopic arm

The telescopic tube (4) can be adjusted
continuously.
1. Loosen the quick release
lock (3) and change the length
of the telescopic tube (4) by
pushing and pulling.
2. Then fix the quick release
lock (3) permanently in place.
Operating the long-handle
hedge trimmers
ANGLING THE CUTTING HEAD
To cut sloping edges or the top of the
hedge, the cutting head can be swivelled
into 6 positions.
Press the locking knob (22) and
simultaneously swivel the cutter
head (2). This locks into the de-
sired position when the lock but-
tons are released.
WORKING INSTRUCTIONS:
• While cutting, make sure that you do
not touch any objects such as wire
fences or plant supports. This can
cause damage to the cutter bar.
• If the blades become jammed with
solid objects, turn the device off im-
mediately and remove the object.
• Do not cut with blunt or worn blades,
as otherwise you will overload the
motor and gears of your machine.
• Carry the device with the cutting unit
facing backwards. Attach the blade
guard during transport.
CUTTING TECHNIQUES
• Cut thick branches beforehand using
a branch clippers.
• The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or
up and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge,
so that cut branches fall to the
ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
GB
71