Publicidad
Idiomas disponibles
Idiomas disponibles
Hydro Transmission
(O)
(E)
(L)
(B)
(A)
(P)
(N)*
NOTE: This Operator's Manual covers several models. Riding
mower features may vary by model. Not all features in this
manual are applicable to all riding mower models and the riding
mower depicted may differ from yours.
NOTE: All references in this manual to the left or right side and
front or back of the riding mower are from the operating position
only. Exceptions, if any, will be specified.
Throttle/Choke Control or Throttle Control
Lever (If equipped) (A)
THROTTLE/CHOKE CONTROL LEVER (IF EQUIPPED)
The throttle/choke control lever is located on the left side of the
riding mower's dash panel. This lever controls the speed of the
engine and, when pushed all the way forward, past the detent
position, closes the choke for cold starting. When set in a given
position, the throttle will maintain a uniform engine speed.
NOTE: When operating the riding mower with the cutting deck
engaged, be certain that the throttle/choke control is always in
the FAST
position.
THROTTLE CONTROL (IF EQUIPPED)
The throttle control is located on the left side of the riding
mower's dash panel. When set in a given position, a uniform
engine speed will be maintained.
OPERATION
30" 6-Speed Transmission
(C)
(F)
(G)
(D)
(L)
(A) (B)
(M)
(N*)
(K)
(J)
(P)
(N)*
(H)
(I)
(M)
(N*)
(K)
(J)
*--Refer to Oil Fill Cap for location of your oil fill cap.
Figure 18
Push the throttle control handle forward to increase the engine
speed. The riding mower is designed to operate with the throttle
control in the FAST
deck is engaged.
Pull the throttle control handle rearward to decrease the
engine speed.
Ignition Module (B)
Never leave a running machine unattended. Always
disengage PTO, set parking brake, stop engine and
remove key to prevent unintended starting.
The ignition module is located on the left fender of the riding
mower seated in the operator's position, adjacent to the
throttle/choke control or throttle control.
IGNITION MODULE WITH REVERSE CAUTION MODE
(IF EQUIPPED)
To start the engine,
insert the key into the
ignition switch and
turn clockwise to the
START
position.
Release the key into
the NORMAL MOWING
MODE
position
once the engine
has fired.
To stop the engine,
turn the ignition key
counter-clockwise
to the STOP
position.
14
24" 6-Speed Transmission
(F)
(B)
(P)
position (full throttle) when the mower
WARNING
(H)
(I)
(J)
(K)
(N*)
(M)
Publicidad
