Deck Installation - Cub Cadet CC30H Manual Del Operador

DECK INSTALLATION

To install the deck, reverse the Cutting Deck Removal instructions
on this page.
CHANGING THE DECK BELT
NOTE: It is possible to change the deck belt with the cutting deck
still installed on the riding mower; however it is much easier to
remove the deck first, change the deck belt, then re-install the
cutting deck.
To change the cutting deck belt, proceed as follows:
1. It is easiest to change the deck belt by first removing the
cutting deck as instructed earlier in this section. Skip this step
if deciding to change the deck belt with the mowing deck still
installed on the riding mower. Otherwise, remove the cutting
deck now.
2. If changing the deck belt with the cutting deck still
installed on the riding mower, lower the deck to the lowest
mowing position.
3. Remove the deck belt from around the riding mower's PTO
drive pulley as shown in Figure 29. Simply roll one side of
the belt off of the pulley and then work it off the pulley by
continuing around the pulley until the belt is off of the pulley.
4. Pull the belt towards the front of the riding mower, pulling it
through and out of the belt keeper rod.
5. Remove the deck belt cover (a) by removing the three hex
bolts (b) that secure it. See Figure 32 for 30" decks and Figure
33 for 24" decks.
(b)
(a)
Figure 32
SERVICE AND MAINTENANCE
(b)
(b)
(b)
(a)
6. Remove the belt keeper (30" decks only) by removing the hex
bolt (a) that secures it. See Figure 34.
7. Loosen the idler pulley (24" decks only) (a) by loosening the
flange lock nut (b) that secures it, enough to allow clearance
for the belt to move past it and off. Remove the belt by
working it off of the deck drive pulley (c) and idler pulley (a).
See Figure 35.
(a)
(c)
8. Change the belt then re-install all the components removed
in the reverse order.
9. Feed the deck belt through the belt keeper rod and work it
around and onto the PTO drive pulley as shown in Figure 29.
26
(b)
(b)
Figure 33
(a)
Figure 34
(b)
Figure 35