After Installation; Care & Cleaning - Fanaway ORBIT LD-36 CTC Manual Del Usuario

Fanaway Orbit Installation Instructions
Symptoms:
•
Loss of control - Fan is only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with the receiver
Repairing Steps:
•
Switch OFF the main power to the ceiling fan for 30 seconds.
•
Switch ON the main power of the ceiling fan. Follow the same process as described in the 'Paring remote
& receiver' section to repair the pairing.
•
Turn on and select the different speed of the ceiling fan to check the operation of the fan.
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few
centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket .
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new
fan disappear during this time.
Please note that this is not a product fault and as such is not covered under warranty – All electric motors are
audible to some extent.
NOTE: Always turn OFF the power at the mains switch before performing any maintenance or
attempting to clean your fan.
•
Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush
or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
•
Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or the
blades and create the possibility of an electrical shock.
14 | P a g e

AFTER INSTALLATION

CARE & CLEANING