Standard Equipment; Accessories; Inspect Hole Cutting Tool; Setup Instructions Model Hc-300 - RIDGID HC-450 Manual Del Usuario

HC-450/HC-300 Hole Cutting Tools
Total Weight ..................31 lbs. (14 kg)
Base ...........................10 lbs. (4.5 kg)
Motor Assembly..........21 lbs. (9.5 kg)

Standard Equipment

• Hole Cutting Tool (Base and Motor Assembly)
• Chuck Key

Accessories

• Hole Saws Arbors
• Hole Saws
• Carrying Case

Inspect Hole Cutting Tool

WARNING
To prevent serious injury, inspect your Hole Cutting
Tool on a regular basis. The following inspection
procedures should be performed before each use of
the tool:
1. Inspect the power cord and plug for damage. If the
grounding prong is missing or the cord or GFCI is
damaged, do not use the tool until the cord has been
replaced.
2. Make sure the switches turn the tool ON and OFF. If
broken, do not use until they are replaced.
3. Inspect the hole cutting tool for any broken, missing,
misaligned, or binding parts as well as any conditions,
which may affect the safe and normal operation of the
tool. If any of these conditions are present, do not use
the tool until the problem has been repaired. Do not
use dull, bent, or damaged hole saws or arbors.
4. Test the Ground Fault Circuit Interrupter (GFCI) to in-
sure it is operating correctly. When test button is
pushed in, the indicator light should go OFF. Re-
activate by pushing the reset button in. If the indica-
tor light goes ON, the tool is ready to use. If broken,
do not use the tool until it is replaced.
5. Clean any oil, grease, or dirt from the handles. This
reduces the risk of injury due to the tool slipping
from your grip.
6. Use only accessories recommended for your tool.
Accessories used for other tools may be hazardous
when used on a hole saw and lead to serious injury.
7. Inspect the cutting edges of your hole saws. If nec-
essary, replace prior to using in your hole-cutting
tool. Dull or damaged cutting edges can lead to injury,
tool breakage, or excessive heat buildup in the work-
piece and the tool.
All manuals and user guides at all-guides.com
Ridge Tool Company
Set-Up Instructions
Model HC-300
WARNING
When setting up the hole saw, it should be un-
plugged and the switch should be in the OFF posi-
tion. To prevent serious injury, the tool must be
properly set up.
1. Determine the size and location of the hole to be
cut. Follow coupling manufacturer's recommenda-
tions for hole size to coupling size.
2. Select hole saw and arbor to the hole size required.
See the RIDGID catalog for saw ordering information.
3. Place the HC-300 on a clean bench or ground to
install hole saw and arbor into drill chuck.
NOTE! The 1 / " pilot drill is recommended for pipe that is
4
installed for it prevents the pipe slug from falling
into the system. If pilot is used, make sure it is
tight in arbor and exposed no more than
4. Ensure the chain assembly and sliding bar handle is
in working order and free to move.
NOTE! It is possible to attach the HC-300 to the pipe as
a complete assembly or in two pieces.
Figure 13 – Model HC-300 Plunger
5. For two-piece mounting, separate the base from the
motor assembly by lifting the motor while pulling the
plunger (Figure 13) located in rear of the left post
(front view). When lifting the motor assembly, use the
handle.
6. Make sure there is adequate clearance to mount
and position the HC-300.
When cutting into an existing system, the
WARNING
pipe must be drained and depressurized. Do not use in
the presence of flammable gas, vapor or dust.
3 /
".
8
9