ISO DIN radio provision with pocket
1. Attach the radio brackets to the
radio trim panel. (Figure A)
2. Attach the pocket to the trim-
panel/bracket assembly with (4) #8
Phillips screws provided. (Figure B)
3. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
4. Slide the radio into the completed
assembly, and then secure with the
with the screws supplied with the
radio. (Figure C).
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra or AXXESS. Reconnect the
negative battery terminal and test the
radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
(Figure A)
(Figure B)
99-7348B
(Figure C)
(Figure D)
3