Start The Machine; Stop The Machine; Turn The Rear Handle; Operation Tips - GreenWorks HT24B05 Manual Del Operario

EN
• Do not touch the blade unless you removed the battery
pack.
• Do not use the machine if the blade is damaged or bent.
• Remove all objects such as cords, lights, wire, or string
from the cutting area which can become entangled in the
cutting blade and create a risk of personal injury.
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIFE THREATENING
AND DANGEROUS. Follow the steps below:
1. Hold the insulated rear handle or put the machine down
and away from you.
2. Disconnect the electrically service to the damaged line
or cord before you try to free the blade.
11.1

START THE MACHINE

1. Push and hold the front handle switch with one hand.
2. Push the trigger with the other hand..
Hold the machine with both hands during operation.
If the machine accidentally falls,it will stop and the blade
will fully stop after a few seconds. The machine will then
locks OFF.
11.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
WARNING
WARNING
NOTE
English
11.3

TURN THE REAR HANDLE

You can use the rotating button to adjust the rear handle to
different positions to cut the hedges easier.
1. Pull the rotating button and turn the rear handle.
2. Release the rotating button until it locks into position.
11.4

OPERATION TIPS

• Do not push the machine through heavy shrubbery. This
can cause the blade blockage. If the blades block,
1. stop the machine.
2. remove the battery pack.
3. remove the blockage.
• Do not try to cut too large stems or twigs.
• Wear protection gloves when you cut.
• Cut the new growth with a wide sweeping action so that
the stems are put directly into the blade.
• You can use a string to adjust the height of the hedge.
1. Stretch a piece of string along the hedge at the desired
height.
2. Cut the hedge immediately above this string.
3. Cut the side of a hedge until it will be narrower at the
top. More of the hedge will come into view in that
way.
12

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
8
CAUTION
CAUTION
WARNING