Connections To The Inlet And Exhaust Connections - Agilent Technologies MS40-S Manual Del Usuario

Instructions for Use

Note also that the pump should be attached to the supporting structure after
replacing the rubber feet with special anti-vibration feet, which should be screwed
to the pump base and to the supporting plane.
After taking the pump out of its packing case, you are advised to make the
following checks:

Connections to the inlet and exhaust connections

Remove the protective caps from both ports. Connect the system to be evacuated
to the inlet flange, using a centering ring with OR and a clamp flange.
For guaranteed reliable sealing, use an OR gasket in NBR or FKM.
NOTE
The inlet duct is equipped with a sieve filter preventing solid parts from entering and
damaging the pump.
MS40-S User Manual
accessories mounted on it. Note that the pump is stable on its base plate and it
should not be necessary to anchor it to the floor with bolts and screws; also
vibrations to and from the pump are greatly reduced by the use of rubber feet.
Pump off the ground. In this case, the user must design a suitable support
structure, remembering the following points:
the plane supporting the pump must be perfectly horizontal;

the structure should be adequately rigid;

the relevant safety precautions should be applied.

a
Ensure that the pump has not suffered any damage during shipping.
b
Check that there are no uncovered or loose parts.
185