Install The Hardware; Mount The Camera - Axis Communications AXIS 216FD Manual Del Usuario

AXIS 216FD/AXIS 216FD-V Installation Guide

Install the hardware

!
IMPORTANT! - The casing of the AXIS 216FD/AXIS 216FD-V is not approved
for outdoor use - the product may only be installed in indoor environments.

Mount the camera

The AXIS 216FD/AXIS 216FD-V can be mounted with the cables routed through the wall/
ceiling, or from above or below. There are cover plates for the openings on both sides of the
dome cover. The AXIS 216FD-V can also be fitted with a metal conduit for protecting the
cabling when connected via the side openings. See the illustations on page 4.
1. Using the drill template, drill two holes in the ceiling/wall.
2. Route and connect all the required cables. See Connect the cables, below.
3. Fasten the camera unit to a ceiling or wall, using screws and plugs appropriate for the
ceiling/wall material.
4. Ensure the camera is positioned so that the tamper-proof screws can be tightened using
the supplied screwdriver.
Mounting on a drop ceiling
To mount the AXIS 216FD/AXIS 216FD-V on a drop (suspended) ceiling, check that the
ceiling material is sturdy enough to hold the weight of the camera.
The camera can also be secured using a plate or board that better carries the weight of the
camera, and which is more suitable for securing the screws.
The AXIS 216FD can also be mounted using the AXIS 216FD Drop Ceiling Mount, which
allows the camera to be mounted more discreetly. Please see www.axis.com for all available
mounting accessories.
Plate or
board
Drop ceiling
AXIS 216FD/216FD-V
Screws
Page 5