Connect The Cables; Assign An Ip Address - Axis Communications AXIS 216FD Manual Del Usuario

Page 6

Connect the cables

1. Connect the camera to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See page 12 for
information on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). If available, this is automatically detected when the
network cable is connected (see above).
• Connect the supplied indoor power supply to the power connector on the camera.
5. Check that the indicator LED:s indicate the correct conditions. See the table on page 13
for further details. Note that some LEDs can be disabled and may be unlit.

Assign an IP address

To make it accessible on the network, the AXIS 216FD/AXIS 216FD-V must be assigned an
IP address.
Depending on the number of cameras you wish to install, the recommended method for
assigning IP addresses in Windows is either AXIS IP Utility or AXIS Camera Management.
Use the method that best suits your purpose.
Both of these free applications are available on the Axis Network Video Product CD supplied
with this product, or they can be downloaded from www.axis.com/techsup
Method
AXIS IP Utility
See page 7
AXIS Camera Management
See page 8
Notes:
• A network DHCP server is optional.
• The AXIS 216FD/AXIS 216FD-V has the default IP address 192.168.0.90
• If assigning the IP address fails, check that there is no firewall blocking the operation.
• For other methods of assigning or discovering the IP address in e.g. other operating systems, see
page 11.
AXIS 216FD/AXIS 216FD-V Installation Guide
Recommended for
Single camera
Small installations
Multiple cameras
Large installations
Installation on a different subnet
Operating system
Windows
Windows 2000
Windows XP Pro
Windows 2003 Server