Rampage JL Trail Doors Instrucciones De Instalación página 4

Installation Steps
Rear door repeat steps 3, 4, 5, 6 to Install driver side rear hinge pins and attach the latch catch with handle
7
Tip: Attach the latch to the outside of the flange as shown.
4 Door Rear Door Assembly
8
Now with everything installed on the doors you can slide the door onto the factory hinge pins. Open the latch teeth carefully close the door
on the vehicle, this will help to align the latch and pins into their correct position.
10
Now tighten the hinge bolts while the door is closed. Tighten the
latch but leave loose enough for minor adjustment. The key to
adjusting the latch is to make sure the latch tooth has full rotation,
and the notched tooth does not catch on the vehicle's striker. Once
you are satisfied with the alignment tighten all hardware.
11
NOTE: Actual application may vary slightly from illustrations.
down as shown.
Tip: Make door catch and latch are lined up before tightening.
9
4 Door Rear Door Assembly
Optional: Install factory side mirrors. Using 2 stand-off supports
and 2 screws to mount side mirror to tube door as shown below.
Once you are satisfied with the alignment tighten all hardware. If
you choose not to install the mirror the plastic plug cap can be
installed into holes.
TOP
BOTTOM
12
Page 4 of 5
4 Door Rear Door Assembly