Hoover HCNP 3876 Manual Del Usuario página 7

In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
Place the appliance on the floor or at a 45° angle,
since it is necessary to work on the bottom of the
appliance.
Take off the bottom right-hand hinge by removing
the screws, pin and washers, then remove the
lower door.
Mark and break the left-hand slot on the panel, in
the insert area.
Fit the panel, and secure with the screws and
caps.
Put the appliance in an upright position and wait
two hours before turning it on.
REVERSING THE OPENING OF THE DOORS
Remove the lower plinth by pulling out the 3
protective plugs and by loosening the screws.
Remove the caps ( A) and ( B) , loosen the screws
and partially remove the panel.
Take the top left-hand hinge from the accessories
kit and fasten it.
To reverse the handles: remove the outer caps
from the right-hand side of the doors.
2 Hours
7 EN
Drill the plinth on the marked left hand-side area.
Unscrew the right hinge.
Remount the hinges and doors working from
bottom to top,
Unscrew the handles from the left-hand side and
move them to the right-hand side, then position
the outer caps on the left-hand side of the doors.