General Description - Zonair3D AIR PRO 100 Guia Del Usuario

GENERAL DESCRIPTION

The unit is supplied fully wired and programmed from factory to perform a check at a variable flow.
The module consists of the following sections: G4 prefilter, GRSystemTM gas filter, fan and H14 absolute filter.
The figure below shows the main components of the module.
PREFILTER AND
GRSYSTEM SECTION
PRODUCT FLOW
RANGE (m 3 /h)
180/150
AIR PRO 100
200/165
270/200
AIR PRO 300
300/220
Maintenance
FAN ABSOLUTE FILTER
SECTION SECTION
Maintenance
UNIT DIMENSIONS CONSUMPTION
H x W x L (mm)
207 x 639 x 929 0,028 (1 un)
207 x 639 x 929 0,056 (2 un)
Thank you for choosing Zonair3D
Please take a few minutes to read this manual carefully before
1- Pressure switch connection cable
(black with 2 terminal blocks joined together)
2- Zonair3D air quality probe connection cable
TM
(probe not included), with 4 marked terminals, 5 and 6
attached to strip, 17 and 18 (attached
to strip)
3- 230 V network cable (2 phases + earth)
4- Main ON/OFF switch
5- PCB registration cover (4 M5 bolts)
6- H14 positive pressure tap
7- Differential pressure switch
8- Connection to the H14 positive pressure switch
9- M5 threads for fixing the anchor brackets
10- H14 negative pressure tap
11- Connection to the H14 negative pressure switch
12- Red LED to indicate HEPA14 filter change
VOLTAGE AND
(KW) FREQUENCY
230 V - 50/60 Hz
230 V - 50/60 Hz
products.
TM
using your AIR PRO 100-300.
WEIGHT Pressure available
(kg) (Pa)
45,5 100/50
46 100/50