TECO 680 Manual De Instrucciones página 104

the Exit key twice (first to exit the procedure and restart the menu, and then to exit
the programme permanently); perform a spin to balance the wheel; otherwise, the system
goes to the third and final programme phase.
OPT PHASE 3
Following the indications on the monitor:
12. turn the wheel up to the position shown on the position indicator;
13. make a double mark on the outer side of the tyre at the 12 o'clock position with a
piece of chalk. If the screen indicates that the tyre should be switched around on the
rim, make a double mark on the inner side using a piece of chalk.
14. confirm you marked the tyre again by selecting Enter
15. remove the wheel from the wheel balancer;
16. turn the tyre on the rim (and invert mounting direction, if required) until the mark made
before matches the valve;
17. refit the wheel on the wheel balancer;
18. press Enter
19. perform a spin. When the spin is over the optimisation programme has been completed
and the weights to be applied to balance the wheel are displayed.
In case an error compromises the final result, the machine signals this with the
E 6 The procedure can now be repeated. The error message disappears by selecting any
of the available functions.
Special Cases
- At the end of the first spin, the message "OUT 2" may be displayed on the screen.
- In this case, it is convenient to exit the programme by selecting exit
values needed to balance the wheel will be shown on the monitor. The execution
of the programme is interrupted, thus not achieving the moderate improvement of
the end results. However, the optimisation procedure can be run by selecting the
OPT continue procedure icon.
- At the end of the second spin, the indication to invert the tyre mounting on the rim
may be displayed. If you do not want to invert it or it is impossible to do so, select the
disable tyre inversion icon. the machine will provide the instructions to complete
the programme without inversion.
The Enable tyre inversion icon restores the inversion function.
- It is possible to exit the optimisation procedure at any time by simply selecting the
104
again to confirm the operation;
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
;
: the weight