Error Messages - TECO 680 Manual De Instrucciones

display this programme
This program is used to optimise the synchronisation of the LCD motor approved by the
manufacturer. Proceed as follows to perform this synchronisation:
- select the
- once selected, the following screen will appear on the monitor;
- to perform the synchronisation, press
the corresponding key directly on the
LCD monitor (read the instructions in the
monitor user manual).
Push the exit key
without performing the synchronisation.
IMPORTANT:
repeat the operation if necessary if syn-
chronisation was not successful.
The machine can recognise a certain number of malfunction conditions and signals them
by displaying the relevant messages.
Wheel not suitable for performing the sensitivity calibration, use a wheel of
A 3
average dimensions (typically 5.5"X14") or larger, but NOT exceeding a weight
of 40kg.
Incorrect dimension settings for an ALU programme. Correct the set dimensions.
A 5
The machine is temporarily unable to select the requested programme.
A 7
Perform a wheel spin, then repeat the request.
Sensor in an incorrect position during calibration.
A 20
bring it to the position indicated and repeat the calibration.
Ultrasonic sensor calibration template in an incorrect position during calibration.
A 20
bring it to the position indicated and repeat the calibration.
Programme available only after selecting one of the following programmes:
A 26
ALU 1P / ALU 2P / Motorcycle Dynamic / Motorcycle ALU or if selected in the
Motorcycle Programme but with the wheel NOT in the centred position.
Optimisation procedure (OPT) already launched by another user.
A 31
Incorrect wheel spin procedure on the wheel balancer without guard. The warn-
A 41
118
.
monitor auto Setting
MONITOR AUTO SETTING icon;
to exit the program

Error mESSagES

– A – Notice Messages
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl