Yakima MEGAWARRIOR Instrucciones De Montaje página 2

•IF YOU HAVE FIXED BARS:
IF YOU HAVE "Q TOWERS"
OR BARS THAT CANNOT MOVE...
Continue to STEP
Q TOWER OWNERS:
NEVER REPOSITION THE Q TOWERS!
ASSEMBLE THE BASKET.
• Remove the machine screws from the
ends of the LoadWarrior tubes.
LOAD BASKET ONTO RACKS.
Center basket over your rack's crossbars.
POSITION THE SUPPORT BRACKETS
ABOVE YOUR VEHICLE'S CROSSBARS.
• Place the brackets
OUTSIDE of the
basket frame.
• Tabs on brackets face
INBOARD.
.
Pry open the
SnapArounds,
attach them to the
LOWER FRONT BAR.
• Insert screws with
washers into each joint
and tighten them.
DO NOT ATTACH BRACKETS
TO UNSTABLE POINTS.
A friend
would make
Do not attach brackets at these locations.
this easier .
KEEP BAR
BELOW
TAB!
It may be necessary to move the
bracket to a new position, or to adjust
the basket position.
•IF YOUR BARS MOVE:
IF YOU HAVE BARS THAT CAN BE MOVED...
Move the bars to minimum 30" apart.
TIGHTEN YOUR CROSSBARS
IF YOU LOOSENED THEM.
ATTACH FAIRING TO EITHER END OF BASKET.
• Insert bolts through washers, fairing
and SnapArounds.
• Attach knobs and TIGHTEN.
NOTE: The fairing can fold
down when carrying
accessories and long loads.
(SIDE VIEW)
POSITION THE COVER BRACKETS.
Position cover bracket onto installed
support brackets.
Hooked tab should cover the larger
support bar.
Arrow points inboard to
center of vehicle.