TATRA TW.F50+DR Manual Del Usuario página 37

- During watering, the cycle
indicator blinks rapidly with
an interval of 0.3 seconds
- The dishwasher doesn't draw
water.
- Dishwasher does not start
washing.
- Dishwasher doesn't do
rinsing.
- The dishwasher draws water
slowly.
- A washing program takes
very long, the machine begins
the regime of rinsing, cycle
indicator blinks rapidly with
an interval of 0.3 seconds.
- Poor quality of washing.
- Dishwasher does not heat
water.
- The dishwasher draw more
water than necessary.
- Check the pressure in the water system
- Check if the water tap is open
- Check if the water hose is not clogged or bent
- Make sure the drain plug is in place.
- Check if the water tap is open.
- Check that the water hose is not clogged or bent.
- Check if the power indicator is on.
- Drain all the water from the dishwasher, fill it again with
water.
- Check if the water tap is open.
- Check if the water pressure is at least 2 bar.
- Make sure that the rinse aid blades are not clogged.
- Check that the water hose is not clogged or bent.
- Drain all the water from the dishwasher, fill it again with
water.
- Make sure that the water temperature in the feed is within
the specified values.
- Check the water level in the tank.
- Possible heater malfunction, please, contact technical
support.
- Check the quality of detergent and rinse aid and their
level.
- If the blades of the sprinkler are clogged, clean them.
- Clear all the filters.
- Check the water pressure.
- Do not put the dishes in the dishwasher without cleaning
them from the remnants of food.
- The dishwasher is not adjusted specifically for washing
glasses. With time, the glasses may get spots and drips.
- Spots on the dishes can be formed due to calcium. You
may need to use a softener.
- If you are using a softener, check the level of salt or
detergent.
- Drain all the water from the dishwasher, fill it again with
water.
- Make sure that the water temperature in the feed is within
the specified values.
- Check the water level in the tank.
- Possible heater malfunction, please, contact technical
support.
- Drain all the water from the dishwasher, fill it again with
water.
- Clear all the filters.
- Make sure the plug and drain are not clogged.
- Clean the drain pump filter.
EN
37