TATRA TW.F50+DR Manual Del Usuario página 38

EN
- The dishwasher doesn't drain
water.
7. CLEANING
Clean the dishwasher inside and outside. Before cleaning, be sure to observe the following
points.
•
Before cleaning, be sure to turn off the dishwasher and power off.
•
Remove all the parts that can be removed manually.
•
Use only warm water and non-corrosive detergents to clean the stainless steel
dishwasher parts. Wipe dry with a soft cloth.
•
It is strictly forbidden to use chloride detergents.
•
Do not wash with water under pressure.
•
Do not wash the dishwasher inside or outside with a hose.
•
If you find that the blades of the sprinkler are clogged, unscrew the hub screw, remove
the blade and, rinse with hot water on the back of the nozzle. Rinse them in cold water
before reinserting.
•
Use hot water to clean the filters. Rinse them in cold water before reinserting.
•
When cleaning the dishwasher internally, be careful not to get hurt by sharp pieces of
broken glass or plates that may be inside the dishwasher.
•
Clean the dishwasher externally first with a dry cloth. After that, wipe the surfaces with
tools designed for stainless steel surfaces.
•
After cleaning the dishwasher, leave the door open.
•
If the dishwasher will not work for a long time, it is necessary to drain the water in the
pump and boiler.
See a visual diagram of cleaning the blades of the dishwasher sprinkler below.
Do not forget that in the case of cleaning without following the requirements mentioned
above, youcan harm yourself, as well as adversely affect the equipment and appearance of your
dishwasher.
7.1. Device disposal
At the end of the period of operation, the equipment must be disposed in accordance
with the local requirements. It is recommended to contact the organization or service
specializing in recycling on this issue.
38
- If, still and all, the dishwasher does not stop to draw
water, turn off the electricity and water supply and contact
the service center.
- Before draining, remove the plug in the tank.