Publicidad
STEP 7
Slide the back of the unit into the
mounting bracket and line up the
center mark on the front of the
cabinet from step 1 with the center
mark of the front of the unit.
NOTE: For frameless application,
the mounting bracket is not used.
STEP 8
While holding the unit against the
bottom of the upper part of the
cabinet, ensure the front of the
unit is flush with the face of the
cabinet and the two marks are
aligned. Using the 3/32" drill bit,
pre-drill cabinet through the holes
in the front of the unit (See Figure
7). For frameless, also pre-drill (2)
holes in the back.
3
32
STEP 9
Gently fasten the unit to the front
of the cabinet using (2) 1-1/4"
screws provided. For frameless
cabinets, also fasten (2) 1-1/4"
screws to the back. Do not
over tighten as this could split the
wood.
STEP 10
Place hooks in any arrangement
(See Figure 8).
NOTE
For dual installation, measure the
largest item to hang on each side
and space units accordingly.
To get the most out of your space,
hang all large diameter items on
one side and smaller items on the
other.
4
Wood block needed for inset application
Figure 7
Figure 8
Customer Service: 800-626-1126 | rev-a-shelf.com
Pre-drill 2 holes
Publicidad
