Cleaning Your Appliance - TEFAL Easy Soup BL841138 Manual Del Usuario

CLEANING YOUR APPLIANCE

• Before first use or to clean the appliance as indicated below:
– Open the appliance
MAX level) (fig
– Put the top back on
– Press the P4 Easy cleaning button
– When you hear the beep indicating the programme has finished, open the appliance
empty the water and rinse inside the jug
• Do not immerse the appliance in water. Do not place the motor unit
running water.
• If necessary, once the appliance has cooled down, wash the blade under the tap
finish by cleaning the inside of the jug and the motor unit with a damp sponge.
• If there are still stains on the inside of the jug, leave it to soak for a few hours in hot soapy
water, then remove the residue with a plastic scourer.
• Rinse the bowl.
• Be careful when you remove the motor unit
extremely sharp.
• To clean the outside of the motor unit
carefully.
• Do not put washing-up liquid in the jug while the easy-cleaning programme is running (risk
of overflowing during the cleaning cycle).
• The appliance is not designed to be cleaned in a dishwasher.
• TIP: Some foods may stain the bowl of your device. This poses no risk whatsoever to your
device or to your health. To remove stains, add some water mixed with a small amount of
cleaning product intended for use in your dishwasher (e.g. a tab, liquid, powder) to the bowl
of your device. Leave overnight to soak. Then, gently scrub with a sponge and the stains will
disappear.
WHAT TO DO IF YOUR APPLIANCE DOESN'T WORK
PROBLEMS
The appliance does not
work.
68
(fig 1) and fill the jug with 1.2 L of hot water from the tap (up to the
3). Do not add washing-up liquid to the jug.
(fig 5) and plug it in
(fig
The plug is not connected
or switched on at the mains
power socket.
The motor unit
correctly
locked in.
(fig 6).
10).
(fig 11).
(B) and when cleaning the blade, which is
(B) and the walls of the jug (I), use a damp cloth. Dry
CAUSES
(B) is not
positioned or
(B) or the jug
(fig 12)
SOLUTIONS
Plug your appliance into a
power socket. Ensure that
the power cord is correctly
inserted into the socket on
the side handle and mains
socket.
Remove some of
ingredients.
Check that the contents
to not exceed the MAX
level and ensure that the
ingredients are
evenly over the base of the
jug.
(fig 1),
(I) under
and
the
spread