Tool Assembly - Milwaukee 6018 Manual Del Operador

To reduce the risk of injury, always unplug tool before
attaching or removing accessories or making adjustments.
Use only specifically recommended accessories. Others
may be hazardous.
Random Orbit Sanders
Random orbit sanders combine a small orbiting action with free floating
rotation. The resulting motion is a random pattern that produces an even,
swirl-free finish on a variety of materials.
Selecting Sandpaper and Grits
Sandpaper can be made from various grit materials and these should be
selected according the material to be sanded. The guidelines below list
materials and grit materials that should be used with them.
• Fine woodwork - garnet or aluminum oxide
• Rough woodwork - aluminum zirconia or ceramic aluminum oxide
• Manufactured wood products (particleboard, medium density
fiber board etc.) - silicon carbide or aluminum oxide
• Solid surfacing materials (Corian, etc.) - silicon carbide or
aluminum oxide
• Metals - emery or aluminum oxide
Sandpaper is also graded by coarseness. Start your work with an abra-
sive grit just coarse enough to remove high spots and excessive rough-
ness. Follow with a second sanding using a grit one or two grades finer.
Continue with successively finer grits until you obtain the desired finish.
Do not switch from a coarse grit to a very fine grit in one step because it
may be difficult to remove the marks made by the coarse grit abrasive.
Use the finest grits practical for the roughing operation, and finish by
using successively finer grits.
Type
Grit
60
Ideal for initial sanding on rougher surfaces.
For fast stock removal. Rough sanding and
Course
stripping of painted and rusted surfaces.
80
100
For intermediate sanding and removal of
Medium
minor surface imperfections.
120
150
Ideal for fine sanding prior to staining,
Fine
180
priming or sealing.
220

TOOL ASSEMBLY

WARNING!
Typical Application
Attaching Sandpaper Discs
Cat. No. 6018 is designed to be used with sanding discs that have a PSA
(pressure sensitive adhesive) backing. Cat. No. 6019 is designed to be
used with sanding discs that have a hook and loop backing.
1. Unplug tool and place it on a flat surface with pad up.
2. For Cat. No. 6018, clean dust and debris from pad face with a dry
cloth. Do not use solvents or immerse pad in liquids as this may
damage the pad.
3. Align holes in sandpaper with the dust extraction holes in the sand-
ing pad and firmly press the sandpaper onto the pad.
NOTE: Sanding disc sizes vary. Choose a sanding disc between
4-3/4" to 5" in diameter.
To secure the sanding disc, run the sander on scrap, pressing
down firmly on the sandpaper.
4. To remove the sandpaper disc, peel it away from the pad.
NOTE: When using PSA sanding discs, do not store tool with sand-
paper disc on pad. Due to heat generated while sanding, discs left
on the pad for extended periods may be difficult to remove.
Attaching Dust Bag (Fig. 1)
To attach dust bag, slide bag's entry port over sander's dust exit spout
until detent engages with hole in entry port.
To remove dustbag, gently twist entry port and pull it away from dust exit
spout.
For best results, empty dust bag when it is no more than half full. To
empty dust bag, remove bag from sander. Unzip bag and gently tap to
remove dust.
Fig. 1
Dust exit spout
Entry port
page 5