Tabla de contenido
Publicidad
7/22 - Recommendation booklet & Albon liner product line warranty card
FOREWORD
The ALBON team would like to thank you for your business and congratulate you on your
ALBON, a French manufacturer, has been providing unique expertise in manufacturing
pool liners, reinforced membranes and covers for over 30 years. Over 350,000 pools are
equipped with liners or protections manufactured by us. Every year, 2 million m
produced by our factories, but every item produced is unique!
Utmost attention is paid to liners during the manufacturing process. Quality control
is carried out before packaging.
In this document, you will find our recommendations for use and your guarantees.
Please read carefully and keep in a safe place.
Enjoy swimming in your pool with its ALBON liner!
1. Recommendations for installation
1.1 Your references
Fig 1
Find the number featured on your liner's packaging and write it down in the
corresponding section of the guarantee at the back of this leaflet. You may
find it very useful if you call our staff..
Fig 1
1.2 Preparing the pool
- - Clean the inside of the liner fastening rail.
- - Clean the walls.
- - Clean the bottom of the pool (vacuum cleaner).
- - Dismantle the flanges and clean the screw housings on the flanges of the
embedded parts (use a small drill bit and a vacuum cleaner).
- - Clean the bottom of the pool (dry out and suction of the water in the bottom
of the pool), disinfect the pool and carry out fungicide treatment shortly
after installation.
The masonry surface must be perfectly smooth.
1.3 Installation
A 75/100° liner must be installed within a 15 to 25°C temperature range.
1.3.1 Installing the felt underlay
Wearing socks, Unroll the felt underlay. Glue the edges and cut any excess to
obtain an even thickness.
CAUTION
Glue the felt underlay using special felt adhesive (in pots or spray), do not use
"barnier" type adhesive tape.
No extra thickness:
• Thin layer of adhesive.
• Glue the joins edge to edge, without overlapping.
choice.
1.3.2 Installing the liner
Fig 2
The liner is rolled with the step side on the outside.
are
2
Small pool side (or stairs)
Fig 2
Fig 3
Unroll the liner towards the deep end.
Fig 3
Fig 4
Unfold the liner across its width.
Fig 4
CAUTION
• Lift the liner correctly to prevent it from rubbing against the concrete by accident.
• To remove the protection covering the liner, do not use cutters to cut the
adhesive, remove it by hand.
1.4 Finishes
1.4.1 Liner suction
Crease-free installation of the liner can only be achieved through excellent
suction and therefore a maximum vacuum between the masonry and liner.
This mandatory step involves imagining the final result (with water) before
starting to permanently fill the pool. Any liner that is badly positioned at
this stage will remain so after filling.
Fig 5
You must perform pool suction from the steps (where creases
are most likely to appear) using an industrial vacuum cleaner,
and, if possible, add at least a second suction point in the pool.
In any event, do not hesitate to shut off the suction and reposition the liner
in the case of creases and poor seam positioning.
To the big pool
Small pool side
(or stairs)
7
Publicidad
Tabla de contenido
