Chicco baby hug 4 in 1 Manual De Instrucciones página 17

Position 4 – Highchair and first chair at the table mode
(Fig. 15c)
seated in the product. In this case it will be slightly more
WARNING: Always check that the backrest is properly
locked before use.
USING THE SAFETY HARNESS
will be a crotch strap, two waist straps and two
shoulder straps (Fig. 16).
17. CRIB MODE - WARNING:
safety harnesses making sure to keep them out of
the reach of your child (Fig. 17).
18. RECLINED CRADLE MODE - WARNING: A 3-point
restraint system must be used: crotch strap + waist
straps (Fig. 18).
19. After placing your child in the seat, reclined cradle
mode, fasten the straps by passing the two prongs
straps so that they fit closely around your child's
waist (Fig. 19).
20. HIGHCHAIR AND FIRST SEAT AT THE TABLE
MODE - WARNING: A 5-point restraint system
must be used: crotch strap + waist straps + shoulder
straps (Fig. 20).
WARNING: In this configuration the toybar must al-
ways be positioned behind the backrest.
21. After placing your child in the seat in highchair
mode, fasten the straps by passing the two prongs
through the shoulder strap buckle (Fig. 21) and then
height of the shoulder straps so that they correctly
fit your child's shoulders.
Always make sure that the straps are fastened correctly.
WARNING
straps by inserting them in the crotch strap and check
that they are tight enough and properly fastened.
or for use in the crib/reclined cradle configuration).
out from the holes in the fabric (Fig. 22-22a-22b) until
they are hidden on the seat frame and pull the shoulder
straps out from the fabric holes on the backrest (Fig. 22c
-22d). After removing the safety harnesses, make sure
that the harnesses are correctly re-assembled.
steps below:
assemble the waist straps and crotch strap. For the
shoulder straps, pass the strap through the hole as
er is positioned as shown in the figure.
through the fabric ring of the harness (Fig. 23a).
Having performed this operation correctly, pull the har-
ness downwards until the fabric ring is turned inside out
(Fig. 23b-23c).
according to the size of your child.
BRAKES
24. All 4 wheels have brakes; to activate the brakes push
down the little lever on the wheels (Fig. 24).
WARNING:
must be locked at all times.
upwards (Fig. 24a).
TOYBAR WITH LIGHTS AND SOUNDS
lights panel that is activated by pressing the buttons
on the upper section (Fig. 25).
F2 : Plays fun music
F3 : Plays lullabies
WARNINGS REGARDING TOYBAR ELECTRICAL
PARTS
on the toybar battery compartment cover with a
teries and fit new ones, making sure that the battery
polarity is correct (as shown on the product); close
the battery compartment cover and tighten the
alent to the type recommended for this product ( 2 x
children.
vent any possible liquid leaks from damaging it.
used for a long period of time.
of the product.
the environment; they must be disposed of through
waste sorting.
mediately, making sure to clean the battery compart-
ment; thoroughly wash your hands if they have come
- into contact with the liquid.
-
they may explode.
as the toy may not work properly.
17
-
-
-
-