Speedaire 48UY04 Instrucciones De Funcionamiento Y Manual De Piezas página 11

INSTALLATION INSTRUCTIONS (CONTINUED)
Lubrication
Before operating compressor,
ensure oil is filled to the center of
the sight gauge (see figure 5).
Using any other type of oil may
shorten pump life and damage
valves.
Recommended Oil (2 Options)
Single viscosity SAE30 ISO100 nondetergent
compressor oil. Part number 4ZF21 or 1WG50.
10W30 synthetic oil such as Mobile 1 or 1WG49.
Oil Capacity
Approximately 8.5 oz.
Remove cap from oil fill opening. Install breather (found in
parts bag with this manual). Check oil level. See specification
label on compressor pump for the proper oil capacity and
oil type. All lubricated compressor pumps discharge some
condensed water and oil with the compressed air. Install
appropriate water/oil removal equipment and controls as
necessary for the intended application.
Do not use regular automotive oil. Additives in regular motor oil
can cause valve deposits and reduce pump life. For maximum
pump life, drain and replace oil after the first fifty (50) hours of
operation. Then perform oil changes every three (3) months.
All manuals and user guides at all-guides.com
Oil Drain
Figure 5 - Lubrication
9
Plug
Sight Gauge
Oil FIll
Area
Full
Low