Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 2
Figure 3
Figure 4
Figure 5
PAGE 2 OF 6
ASSEMBLY CONTINUED
Figure 2a
Frame
Frame
Reinforcements
Figure 3a
Figure 4a
Round
Pin
Axle
1-800-295-5510
uline.com
ATTACH NOSE PLATE, FOLDING NOSE EXTENSION
AND AXLE SUPPORTS
1.
Position frame reinforcements against bottom frame
rail. (See Figure 2a) Slide nose plate into channel on
frame reinforcements, keeping bolt holes aligned.
(See Figure 2)
2. Align axle support with outside rail of frame.
(See Figure 2)
3. Insert four 8mm bolts through the axle supports,
frame, frame reinforcements and nose plate.
(See Figure 2)
4. Slide the folding nose extension bracket over the
8mm bolts protruding from the bolt holes on the
inside of the nose plate. (See Figure 3a)
NOTE: The bolt holes on the bracket are NOT
centered. Make sure the bolt holes are closest
to the back of truck before tightening.
(See Figure 3)
5. Secure with locknuts but DO NOT tighten. (See Figure 3)
ATTACH AXLE AND WHEELS
1.
Lay hand truck down on front so axle supports face
upwards. (See Figure 4)
2. Insert axle through holes in axle supports. Align holes
in axle with grooves on inside of the axle supports. Use
a hammer to tap in the round pins. (See Figure 4a)
3. Slide 3 washers onto each end of the axle. Slide
a wheel onto each end of the axle. Slide another
washer onto each end of the axle. (See Figure 5)
4. Insert a cotter pin through the holes in each end
of the axle. Bend cotter pins using pliers to secure
wheel. Wheels should spin freely. (See Figure 5)
5. Tighten all locknuts.
0421 IH-4124
Publicidad
