Publicidad
Idiomas disponibles
Idiomas disponibles
Overview of Tool Components (A1)(B1)
1. Clamp screw for handrail holder
2. Handlebar
3. Operating handle
4. Operating switch
5. Locking device
6. Throttle lever
7. Suspension Harness
8. Exhaust pipe guard
9. Engine
10. Fuel tank
11. Cutting blade
12. Cutting guard
13. Trimmer head
Problem
The engine stops.
The tool starts, but the
engine has little power.
The tool does not start, or
starts, but does not run.
Engine runs irregularly.
Excessive emission of
smoke.
14. Allen key
15. Spark plug wrench
16. Gasoline Blending tank
17. Carrying strap
18. Locking button
19. Locking screw
20. Retention pin
21. Cutting line
22. Bracket base
23. Rotatable bracket
24. Bigger spring
25. Smaller spring
26. Bracket cover
Possible C ause
Incorrect adjustment of carburetor
Incorrect adjustment of choke lever
Air filter is dirty
Incorrect adjustment of carburetor
Incorrect procedure when starting
Incorrect adjustment of carburetor
Spark plug is full of soot
Gasoline filter plugged up
Incorrect air gap at spark plug
Spark plug burnt down
Incorrect air gap at spark plug
Spark plug burnt down
Trouble shooting
Have the carburetor adjusted by a
technician.
Switch to
Remove the filter made of foamed
plastic, wash in soapy water and
reinsert when dry.
Have the carburetor adjusted by a
technician.
Observe the instructions in "Starting
when Engine is Cold 1-8".
Have the carburetor adjusted by a
technician.
Clean the spark plug, correct the air
gap, or replace the spark plug.
Replace gasoline filter
Clean the spark plug, correct the air
gap, ideal is 0,25"/0.63 mm, or replace
the spark plug.
Have the carburetor adjusted by a
technician.
Empty the tank, fill in the correct
mix: 2-stroke mix 40:1.
21
G
B
Publicidad
