KENMORE ELITE ULTRA WASH 665.1377 Serie Manual De Uso Y Cuidado página 10

Cup shelves
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
shown below.
Deluxe adjustable 2-position top rack
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
both the top and bottom racks. Adjusters are located on each
side of the top rack.
To raise the top rack
Lift the rack on both sides until the rack is level.
NOTE: The top rack must be level.
To lower the top rack
Depress both tabs on rack adjusters, as shown above, and slide
the rack back to its original position.
Removable top rack
The removable top rack allows you to wash larger items
such as stock pots, roasters, and cookie sheets in the bottom
rack.
IMPORTANT: Remove dishes prior to removing the rack from the
dishwasher.
10
All manuals and user guides at all-guides.com
To remove the top rack
1. Pull the rack forward slightly to access clips.
2. While pressing the ridges in, push back on the clip until the
outer side releases. Slide the clip to the inside of the track
edge to remove the clip.
3. After removing both clips, pull rack out.
To replace the top rack
1. Place the rollers on each side of the rack into the rack tracks
and push the rack back.
2. Align the open side of the clip with the inside edge of the rack
track.
3. Push the ridges and slide the clip toward the outside rack
edge until it locks into place.
4. Repeat on the other side.
5. Pull the rack out all of the way to ensure clips are fully seated.
Flexible tines
The row of tines on the left-hand and right-hand sides of the top
rack can be adjusted to make room for a variety of dishes.
To adjust the flexible tines
1. Grasp the tip of the tine that is in the tine holder.
2. Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
No-flip clips (on some models)
The no-flip clips hold lightweight plastic items such as cups, lids,
or bowls in place during washing.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.