Gym Master GM97816 Manual De Instrucciones página 17

DRIVE BELT TENSIONING ADJUSTMENT
If you have tensioned the running belt and are still experiencing a slipping sensation, call
your dealer. Only an authorized dealer should perform tensioning of the drive belt.
LUBRICATING THE DECK
A well-lubricated deck will ensure high performance of your treadmill and reduce the level
of normal war and tear to important components. This treadmill has been pre-lubed at the
factory. However, for optimal performance, the running deck may require periodic
lubrication. With average usage ( 30 minute workout session at 5-6km?h 3 times a week
for two people) lubricate every four to six months. Your may adjust the timing of the
lubrication based on the intensity of the treadmill use level.
To check the lubrication level, simply lift the running belt, and put your hand as far into the
center of the belt as you can reach. If your hand shows signs of silicone, then it does not
need additional lubrication. If the board feels dray and there is very little evidence of
silicone on your hand, then additional lubrication should be added.
TO LUBRICATE THE DECK:
1. Stop running belt so that the seam is located on top and in the center of the deck.
2. Insert nozzle into spray head of lubricant can.
3. Lift running belt.
4. Position nozzle between the belt and the board approximately 200mm (8" ) from the
front of the treadmill.
5. Apply the silicon from the front to the rear of the treadmill on each side of the treadmill.
Try to reach the spray as far into the center of the running deck as possible. The
spray time should be approximately four seconds for each side.
6.Spread the silicon by running the treadmill at 1 Km/H and step gently on the belt from left
to right. Do that for a few minutes and allow the silicon to soak into the belt.
CAUTION!
Over tightening of the belt will severely shorten the life of the belt and may cause further damage to
other components.
NOTE:
A well lubricated deck will ensure longevity of your treadmill in addition to providing you with the
optimal performance.
DANGER!
To reduce the risk of electrical shock, always unplug the treadmill from the electrical outlet
immediately after use and before cleaning.
Owner's Manual
16
17