Installation; Points To Be Considered When Re-Transporting Your Refrigerator; Before Operating Your Refrigerator; Electric Connection - Blomberg BRFB1812SSL Manual Del Usuario

3

Installation

B
Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.
Points to be considered
when re-transporting your

refrigerator

1. Your refrigerator must be
emptied and cleaned prior to any
transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget...
Every recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1. Is the interior of the refrigerator dry
and can the air circulate freely in the
rear of it?
2. Please keep 50 mm distance
between the backside of the
refrigerator and the wall"
3. Clean the interior of the refrigerator as
recommended in the "Maintenance
and cleaning" section.
All manuals and user guides at all-guides.com
4. Plug the refrigerator into the wall
5. You will hear a noise as the
6. Front edges of the refrigerator may

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in
• The power cable plug must be easily
• The specified voltage must be equal
• Extension cables and multiway plugs
B
B
10
EN
outlet. When the fridge door is open,
the fridge compartment interior light
will come on.
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
compliance with national regulations.
accessible after installation.
to your mains voltage.
must not be used for connection.
A damaged power cable must be
replaced by a qualified electrician.
Product must not be operated before
it is repaired! There is danger of
electric shock!