Maintenance; After Each Use - Laerdal CPRmeter 2 Manual Del Usuario

Warning
Do not interrupt CPR to replace the battery. Continue CPR without
feedback from the CPRmeter 2.
Notes
• If the remaining battery power during use becomes too low to
sustain further operation, the low-battery icon is shown for 10
seconds and then the CPRmeter 2 turns itself off.
• After removal of low-batteries, wait 10 seconds before inserting new
batteries.

After each Use

After use on a patient, the CPRmeter 2 may be contaminated and
should be handled appropriately.
1. Place the contaminated CPRmeter 2 in a plastic bag until it can
be cleaned (do not insert a contaminated CPRmeter 2 into
its casing).
2. If it is visibly soiled, wipe the CPRmeter 2 with a soft cloth or
paper towel to remove as much contamination as possible.
3. Remove the Patient Adhesive from the back of the CPRmeter 2.
4. Clean the CPRmeter 2 as described under Cleaning and
Disinfection. Proper cleaning is required to achieve disinfection.
5. Check the exterior of the CPRmeter 2 for signs of damage.
Contact Laerdal to arrange for replacement if needed.
6. Apply a new Patient Adhesive to the device as described in
Setup- Apply Patient Adhesive.
All manuals and user guides at all-guides.com
23

Maintenance