Safety Warnings - Futuro Futuro SKYLIGHT Serie Manual De Instalación

Do not use abrasive products. All the above operations must be performed
after having disconnected the appliance from the mains power supply.
M

SAFETY WARNINGS

The electrical system features an earth connection in compliance with interna-
tional safety standards; furthermore, it is compliant with the European standard
for electromagnetic compatibility.
Do not connect the appliance to flues (from boilers, fireplaces, etc.). Make sure
the mains voltage corresponds to the values on the rating plate located inside
the range hood. The minimum safety distance between the cooktop and the
range hood must be at least 65 cm.
Never cook on "open" flames under the range hood.
Check deep-fryers during use: superheated oil may be flammable.
- Ensure there is adequate ventilation of the room when the rangehood is used
at the same time as appliances burning gas or other fuels.
- Do not flambe under the rangehood
- The exhaust air must not be discharged into a flue which is used for exhaust-
ing fumes from appliances burning gas or other fuels.
- Ensure that all regulations concerning the discharge of exhaust air have been
fulfilled before you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the ap-
pliance by unplugging it or using the main switch. The manufacturer disclaims
all liability for any damage that may be directly or indirectly caused to people,
things and animals due to the failure to follow all the instructions provided in
this booklet and above all the warnings relating to the installation, operation
and maintenance of the appliance.
N
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting
from printing or transcription errors. The manufacturer reserves the right to
modify its products as it considers necessary or in the interests of the user,
without compromising their essential safety and operating characteristics.
O
RANGE HOOD ASSEMBLY
(the assembly layout are indicative and valid for the 90 and the 140 with mo-
tors version)
Set the hole on the false ceiling, according to the indications of the drawings
at the beginning of the booklet. Fix the provided jig on the internal part of the
false ceiling, so not to be visible, to increase the reinforcement, as indicated
in figure (OA-OB-OC).
Note: if the MU is installed on the hood and on the FC flange connection and the pla-
stic check valve is used, it is recommended to install the latter on the conveyor
outlet. The installation instructions are found inside the valve packaging.
28
All manuals and user guides at all-guides.com