Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Front wheel toe in / Camber
The front wheel toe-in and camber are not
adjustable on your tractor. If damage affects
those adjustments, contact TRAPP nearest
authorized service center.
How to remove wheels for repairs
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear wheel
contains a square key - Do not lose it).
3. Repair tire and reassemble.
Note: On rear wheels only: align grooves
in wheel hub and axle. Insert the square
key.
4. Replace washers and retaining ring securely
in axle groove.
5. Replace axle cover.
Note: To seal tire punctures and prevent flat
tires due to slow leaks, tire sealant may be
purchased from your local parts dealer. Tire
sealant also prevents tire dry rot and
corrosion.
110
All manuals and user guides at all-guides.com
To start the engine with
a weak battery
If your battery is too weak to start the engine,
it should be recharged. (See "Battery" in
the maintenance section of this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
To attach jumper cables
1. Connect one end of the Red cable to the
2. Connect one end of Black cable to the
3. Connect the other end of the Black cable
To remove cables, reverse order
1. First remove Black cable from chassis and
Warning!
Lead-acid batteries generate
explosive gases. Keep sparks, flame
and smoking materials away from
batteries. Always wear eye protection
when around batteries.
Important: Your tractor is equipped with a
12 volt system. The other vehicle must
also be a 12 volt system. Do not use your
tractor battery to start other vehicles.
Positive (+) terminal of each battery (A-B),
taking care not to short against tractor
chassis.
Negative (-) terminal (C) of the fully
charged battery.
(D) to a good ground of the chassis, away
from the fuel tank and battery.
then from fully charged battery.
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
