GrowMax Water ECO GROW 240 Manual De Instrucciones página 3

ECO GROW • Setup:
1. Filtration System Bracket
2. GMW Filter Housings
™
3. FloCheck
4. Inlet Quick-Connect
5. Outlet Quick-Connect
Before Installation/Precaution!
Do not install the system where the incoming water pressure may be more
than 90psi (6 k/cm2). If unsure, check the pressure with a pressure gauge,
available at your local hardware store. If your water pressure is more than
90psi (6 k/cm2), install a pressure regulator. Do not use with hot water.
How to install the ECO GROW unit:
1. Begin by connecting the garden spigot quick-connect to your garden
hose or garden spigot (8).
2. Take a length of 1/4" tubing (cut your desired amount) and push
one end into the garden spigot quick-connect (8), and the other end
into the inlet port of the filter system on the right side (4).
3. Push the desired length of tubing into the outlet port of the filter
system on the left side (5), then simply push the other end of the
tubing into the shut-off ball valve (9) and you are ready to water.
4. Optionally, use the indoor connector (10) to install to any 1/2" cold
water inlet.
Regulator
™
6. MaxPur 5 Micron Sediment Filter
7. GMW CleanGreen
8. Water Spigot Connection
9. Ball Valve
10. Optional Indoor Connector
™
Carbon Block Filter