GrowMax Water ECO GROW 240 Manual De Instrucciones página 4

How to Connect and Disconnect
Tubing to Quick Connect Fittings:
Push in Collet
Remove Tube
Push tube firmly into the fitting connector all the way to until the tube
stops. Try to pull the tube out to check the security. If the tube pulls out,
then push all the way in again. Make sure to cut the tubing straight for
best connections.
To disconnect the tubing. First make sure the system is de-pressurized
by turning off inlet water. Push in the "collet" that holds the tube into the
fitting connector. While pushing in the collet you can now simply pull out
the tubing.
Replacing Your Filters:
™
The MaxPur 5 micron sediment filter works as a pre-filter which
™
protects the CleanGreen Carbon Block Filter, extending its life and
contaminant reduction capabilities.
The GMW CleanGreen™ carbon block filter is rated to produce
approximately 10,000 gallons (37,900 liters) of treated water. This is
based on a flow rate of 1 gallon per minute (3.79 liters per minute),
and a source-water of 1ppm (part per million) of chlorine.
Depending on the size of your garden and daily watering time, this filter
will generally last between six and twelve months. It is best to change out
both filters at the same time.
Replacement Filter Pack:
Part# GMWPACK10
Replacements and accessories are available at:
www.GrowMaxWaterUSA.com