Maintenance & Safety - Philips AZ 3010 Guia De Inicio Rapido

CD PLAYER
Programming track numbers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more than once.
1 In the STOP mode, press ∞ or § for your desired
r
track.
2 When your chosen track number appears, press
PROG MODE once to store the track.
s
™ The display shows prog and prog briefly
followed by your selected track number. (See 9)
of
™ If you attempt to programme without first
selecting a track number, no sel is shown.
(See 0)
3 Repeat steps 1 to 2 to select and store all desired
tracks in this way.
™ full is displayed if you attempt to programme
more than 20 tracks.(See !)
4 To play your programme, press 2;.
se
Reviewing your set programme
• In the STOP mode, press and hold down
PROG MODE for more than one second.
™ The display shows all your stored track numbers
in sequence.
ng
Erasing a programme
You can erase the contents of the memory by:
– opening the CD door;
– selecting TUNER source;
– pressing 9 (twice during playback or in the stop
position
™ Display: shows no prog briefly when the
ng
programme is cancelled.(See @)
y
s
d
all
r.
E
All manuals and user guides at all-guides.com
Precautions & General Maintenance (See $)
• Place the set on a hard and flat surface so that the
• Do not expose the set, batteries or CDs to
• Do not cover the set. Adequate ventilation with a
• The mechanical parts of the set contain self-
• To clean the set, use a soft dry cloth. Do not use
CD player and CD handling (See %)
• The lens of the CD player should never be touched!
• Sudden changes in the surrounding temperature
• Always close the CD door to keep the CD
• To clean the CD, wipe in a straight line from the
• Never write on a CD or attach any stickers to it.
MAINTENANCE & SAFETY
system does not tilt.
humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
minimum gap of 6 inches between the ventilation
holes and surrounding surfaces is necessary to
prevent heat build-up.
lubricating bearings and must not be oiled or
lubricated.
any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the
housing.
can cause condensation to form and the lens of
your CD player to cloud over. Playing a CD is then
not possible. Do not attempt to clean the lens but
leave the set in a warm environment until the
moisture evaporates.
compartment dust-free. To clean, dust the
compartment with a soft dry cloth.
centre towards the edge using a soft, lint-free
cloth. Do not use cleaning agents as they may
damage the disc.