Rimage 2000i Manual De Usuario página 21

b. Gently grasp the small metal tabs to move the printer to the left or right.
c. If the printer needs to be aligned from front to back, use the 5/32" hex key to turn the center front
5/32 hex screw clockwise to move the printer toward the front of the Rimage 2000i or
counterclockwise to move the printer toward the back of the Rimage 2000i.
d. To close the printer tray, press
e. Repeat step 1 to check the printer alignment. If necessary, repeat steps 2 – 4 until the printer is
properly aligned.
5. When the printer is properly aligned, tighten the two T25 Torx screws at the front to ensure continued
alignment.
6. Repeat step 1 to check the printer alignment. If necessary, repeat steps 2 – 4 until the printer is properly
aligned.
7. Close the ink cartridge access door.
8. Press the operator button until the operator panel displays EXIT TEST MODE DIAGNOSTIC.
9. When the operator panel displays EXIT TEST MODE DIAGNOSTIC, release the operator button.
Note: If the operator panel displays PAUSE..., press the operator button once. The operator
panel displays RIMAGE 2000i READY.
110763_I
All manuals and user guides at all-guides.com
.
Maintain the Rimage 2000i
17