Sensor Setup - BALDR B0360WST2H2PR-V2 Manual Del Usuario

Powered by batteries:
1. Remove the battery compartment cover.
2. Insert 3x AAA battery matching the polarity(+and-).
3. Replace the battery cover.
SENSOR INSTRALLATION
1. Remove the battery compartment cover
2. Insert 2xAA batteries matching the polarity（+and-)
3. Replace the battery cover

SENSOR SETUP

For example, you can set to Channel 1 for the sensor. But please
ensure the main unit are set to the same channel before
unit to set the channel.The setting order is CH1--CH2--CH3--
Channel scan（from CH1 to CH2 to CH3,8 seconds intervals）,
you must select the same number choices for both the sensor and
the main unit in order to synchronize)
status will last for max 3 minutes,the receiving antenna signal will
flash, if no signal received in 3 minutes, the antenna signal
willdisappear and stop receiving outdoor signal.
again.
MAIN UNIT SETUP
When power on or reset, LCD will full display for 3 seconds with "BI"
sound.
10