AVS Ventvisor Deflector Instrucciones De Instalación página 3

Installation Steps
Apply pressure to the tape flanges to secure.
6
Lower the glass. Buff the rubber
window trim where visor will attach.
8
(1) Remove the triangular plastic mirror cap from the
INSIDE of the door. (2) Loosen but do not remove the
mirror mounting screws using a phillips screwdriver or
nut driver as applicable.
Step 1
10
NOTE: Actual application may vary slightly from drawings.
Step 2
4 Piece Set
The rear visor uses the same attachment method as the
front visor. Open pop out window prior to installation.
Attach visor to the vehicle's painted metal surface. DO
7
Repeat Steps 1 - 7 for opposite side.
Clean the rubber window trim & corner
9
Remove the tape liner from the front & rear flanges.
Peel back 2" (5 cm) of tape liner from each end of top
rear
flange
11
Page 3 of 4
NOT buff surface.
panel where visor will attach.
flange.
top flange
free end
front
flange