Cooper Lighting Solutions Halo home HIWAC1BLE40AWH Instrucciones De Instalación página 2

SINGLE-POLE INSTALLATION (1 Dimmer)
1
Turn OFF power at the circuit breaker
and remove the wall plate
4
Turn the wall dimmer to the OFF
position but leave the wires
connected.
7
Turn OFF power at the circuit breaker
10
Connect the HALO Home Accessory
Dimmer (A) using provided wire
nuts (B).
i. Connect the tagged 'Hot' wire to the
Accessory Dimmer's black wire.
ii. Connect the bare copper or green
ground wire from the wall-box to
the Accessory Dimmer's green wire.
iii. Connect the other dimmer wire
(load) to the Accessory Dimmer's
red wire.
iv. Connect the neutral wire in
the wall-box to the Accessory
Dimmer's white wire. (NEUTRAL IS
REQUIRED).
11
Using the screws provided (C), mount the Accessory Dimmer
in the wall-box and attach a wall plate (not included).
13
Using your smart phone/tablet, follow the online Quick Start Guide to pair this product to your HALO Home account.
support.BringHaloHome.com
2
Leaving wiring attached, pull the
dimmer away from the wall.
5
Ensure wiring is safely separated
and terminals are not touching
anything, and then turn ON power
at the circuit breaker.
8
Use a label or electrical tape to tag
the identified 'Hot'/power wire.
12
3
Verify that there is a neutral wire
available. If not, stop and consult a
licensed electrician.
6
DO NOT TOUCH EXPOSED WIRE OR
TERMINALS. Using a voltage tester,
determine and note which wire still
has power ('Hot').
9
Disconnect the wires and remove the
dimmer.
HOT
Turn ON power at the circuit breaker. (An LED indicator
will start flashing when power is turned ON).
HOT