Publicidad
3.6.2) Connector crimping
– Remove the pre-rounding dies and the adaptor AC130-P from the head (see § 3.6.4).
– From the table (Fig. 6, page 42) select the containing die and indentor recommended for
the conductor size.
– Insert the indentor PS130.../E (93) into the ram (14) (see § 3.6.4).
– Insert conductor into the connector; locate the connector into the containing die; locate
the containing die in the adaptor (see § 3.6.4).
– Operate the tool, commence indent crimping from the barrel end for both splices and
terminals, following the sequence shown below. For every operation ensure the die is
correctly located in the adaptor with its upper slots in line with the internal adaptor pins.
– Each indenting operation is completed when indentor and die are fully closed; it is
recommended to continue pumping until the maximum pressure valve is activated (see
§ 3.3).
INDENTING SEQUENCE
3.6.3) Adaptor fi tting and removal
– Insert the upper adaptor AU130-... (98) into the U-fork head (10) until secured by the
locators (34). To remove the adaptor from the U-fork head, push the adaptor from the
locators and slide out.
– To insert the adaptor AC130-P (91), press the die release pin (04).
Insert the adaptor into the seat of the ram (14), until secured by the retaining pin (02).
To facilitate this operation, an advancement of 3÷4 mm (0.11 - 0.16 in.) of the ram (14)
is suggested.
To remove the adaptor, press the die release pin (04) and slide the adaptor from the
ram (14).
3.6.4) Dies, indentors, pre-rounding dies - fi tting and removal
– The containing die (6) and upper pre-rounding die (95): are located in the adaptor
AU130-... (98) by grooves in the upper face.
– The lower pre-rounding die (94): is inserted or removed from the adaptor AC130-P
(91), by pulling the release button (92).
– The indentor PS130.../E (93): is inserted into the seat on the ram (14).
41
6
1
1
2
ENGLISH
4
3
2
(Ref. to Fig. 5)
Publicidad
