Etac Molift Air 200 Manual Del Usuario página 7

Hand control
The Hand control has 2 buttons for lifting and lowering, or 4 but-
tons if the hoist is equipped with propulsion. The Hand control
has an indicator light that will illuminate when battery level is low
and the lifter requires charging
Do not pull Hand control to move the hoist
along the rail
Mounting sling bar
2
1
3 4
1. Align sling bar in connection point.
2. Push button on locking pin and insert all the way through.
3. Make sure locking pin is properly fastened
4. Push and hold down the button on the locking pin, and pull
to remove locking pin.
Emergency stop / emergency lowering
Emergency Stop
Activation and reset of emergency stop:
Pull to activate emer-
gency stop. The button
will come out, and hoist
will stop.
All manuals and user guides at all-guides.com
Push with finger or use tube
on cord to push button
back in to reset emergency
stop.
4
Electrical Emergency Lowering
Pull and hold to start lowering. Hold until client is
lowered and can be released from sling bar.
Only for emergency use when hand control
does not work!
Manual Emergency lowering
Allen key or bit for power drill can be found inside the lifter.
Remove cover to locate.
Push down and press cover outwards with a flat screwdriver or
coin in the two slots to open cover. Turn the "Brake Release"
handle down (Only for Air 350).
Locate sticker over the hole for manual emergency lower-
ing. Punch hole or remove sticker and insert tool. Rotate
counterclockwise to lower lifting belt. Using a power drill is
recommended.
Service is NOT required if:
1) the Air manual emergency down is used for a known reason, and
2) the belt is undamaged, and
3) the unit is operating normally after the manual emergency lower-
ing procedure.
The new brake override will contribute to this by making emergency
manual lowering less stressful to lift components.
If the unit have had a malfunction with unknown reason, and
manual emergency lowering system has been used, Service is
required.
Molift Air / www.etac.com