TMC Aquarium AQUARAY Control Instrucciones De Funcionamiento página 6

• Lamps will start to dim when the OFF TIME
equals the current time.
R MP has a range of 1 to 240 (1 minute to 4
hours).
• The channel level setting allows the maximum
brightness to be set as a percentage.
• The minimum level settings are in operation
when the unit is in the OFF phase.
Please note: the minimum level cannot
exceed the maximum level. t 'OFF TIME'
the units must both dim and at 'ON TIME' the
units must both brighten.
The PSU must always be connected to Input 1
for correct operation. No damage will result if
not connected, but the timer will not function.
• DEMO mode can be entered by holding the
MODE button during power up. Release the
button when the word DEMO appears on the
display.
In DEMO mode, the lamps continuously
brighten and dim according to the set program
over a 1 minute period. The ramp rate is fixed
at approximately 15 seconds.
Please note: the light bar below the clock will
not move to full brightness in demo mode,
although the lights will.
4