Cleaning Instructions; Assembly; To Connect The Imager To The Imager Handle - Snap-On BK6500 Manual De Instrucciones

7. With dry hands, unplug charger from outlet
once charging completes.

Cleaning Instructions

Unplug charger before cleaning. Do not use any
water or chemicals to clean charger or batteries to
reduce the risk of electrical shock.
1. If present, remove charger from the unit.
2. Remove any dirt or grease from the exterior
of the charger and battery pack with a cloth or
soft non-metallic brush.

Assembly

NOTICE: Be sure to read Battery Precautions
section page 5.
The BK6500 has three main components; the
Viewer Unit, Imager Handle and the imager .
The three main
assembled. Should the user wish to use a different
imager, the imager can be removed by unscrewing
the imager connector in the direction indicated by
the engraved arrow and the word remove.

To Connect the Imager to the Imager Handle

To assemble a new imager to the Imager Handle,
first align the tab on the Imager Handle with the
slot on the imager and mate the connectors (Figure
5). Finger-tighten the connector nut to secure the
pieces. Do not use tools to tighten the connector
nut. Note: BK6500 is not compatible with the
BK5500 and BK6000 Push-Fit style imagers.
Digital Video Scope
components are supplied
Figure 5: Connecting the Imager to the Imager
Handle.
To Install the Magnet Retrieval Accessory: The
unit is supplied with a magnet retrieval accessory
for retrieving small ferrous objects from difficult to
reach places (Figure 6). The accessory is attached
to the imager head by aligning the opening on the
accessory with the flats on the imager head and
pushing in-place. Rotating the accessory 90° locks
it in place. To remove, rotate the accessory until the
clip opening aligns with the flats on the imager and
pull to remove.
Figure 6: Installing Magnet
Snap-on
11